Attention: Your browser is not supported.
Attention: Your browser is outdated, so this website may not display properly.

Plate brake tester BP

Only in combination with P80 digital display.

The BP plate brake tester analyses the brakes of a vehicle under dynamic conditions of each individual wheel for the service- and parking brake. The brake forces and difference left/right of an axle can be measured.

Dynamic brake testing!

The brake plates are designed for surface mount (on floor) or flush fitted (in floor) installation. The hot dip zinc bridge type brake plates are equipped with reliable roller bearings.

BP2: 2-plate brake tester.
BP2T: 2-plate brake tester with integrated sideslip meter.
BP4: 4-plate brake tester.
BP4T: 4-plate brake tester with integrated sideslip meter.

The important brake force ratio front axle to rear axle can also be determined on the BP4 and BP4T.

Required floor space:
1480 x 620 x 54 mm ( l x w x h): Single brake plate.
2180 x 2040 x 54 mm ( l x w x h): BP2
3140 x 2040 x 54 mm ( l x w x h): BP2T
4785 x 2040 x 54 mm ( l x w x h): BP4 and BP4T

With the optional integrated sideslip meter, during the brake test, the dynamic toe-in or toe-out of an axle is presented on the display. The mechanical compensation plate relieves any built-up tire forces which would impair the measurement. This guarantees an accurate sideslip test.

  • Full automatic test.
  • Brake forces left and right per wheel per axle.
  • Brake force difference left to right per axle.
  • Brake efficiency calculation for service- and parking brake after manual weight input.


BP series
Power supply
1PH 230V / 50 Hz
Maximum axle load
3000 kg/measuring
Maximum axle load
4000 kg/drive over
Measuring range
10000 N (brake force)
Measuring range
0 to 20 m/km dynamic toe-in and toe-out (sideslip)
Hot dip zinc
Brochure downloads


PT0015 + beetle2 (2100x1700).png
PT0015 + beetle1 (2100x1700).png
PT0015-2 layout
BP2 lay-out
PT0015-4S layout
BP4T lay-out