Plate Brake Tester (NT2 - P40)

The ESCON NT-series of plate brake testers in combination with the P40 analogue display analyses the brakes of a vehicle under dynamic conditions of each individual wheel for the service- and parking brake. The brake forces and difference left/right of an axle can be measured.

The ESCON P40 is the analogue pointer display for plate brake tester NT2 up to 8 kN. It contains two brake force pointers for the left and right wheel. The difference left-right is indicated by means of a lamp signal.

Standard features:

  • Brake force indication left / right up to 8 kN.
  • Lamp indication for brake force difference left / right: GREEN - YELLOW - RED
  • Microprocessor controlled.
  • Wall bracket included.

End plates for in-floor configurations
Pedal force meter
Pivoting wall bracket

Single plate dimensions: 148 x 62 x 5 cm ( L x W x H)
Dimensions NT2: 220 x 202 x 5 cm ( L x W x H)
Measuring range brake force: 8 kN
Maximum axle load: 2000 kg/measuring, 3000 kg/drive over
Standard hot dip zinc
Power supply: Single phase 220 V / 50 Hz

Dimensions P40: 635 x 465x 165 mm

P40 Analogue Pointer Display

Make a choice

- Cars
- Commercial vehicles
- Caravans & Trailers

Product Groups
- Consoles for roller testers
- Pedal force meters
- Plate brake testers
- Play detectors
- Roller brake testers
- Roller tester add-ons
- Sideslip meters
- Speedometers
- Suspension testers

Disclaimer | Copyright © 2019 Altus-Escon-Company BV, Inc. All Rights Reserved